Go to french website
Go to german website
Anechoic Chambers
Antennas
Attenuators
Calibration kits
Capabilities
Charges
Circulators
Coaxial adapters and connectors
Coaxial cords
Couplers
DC block
Delay lines
Detectors
Dielectric resonators
Diodes
Doublers
Equalizers
Filters
Frequency converters
Frequency synthesizers
GaN / GaAs transistors
GPS products
Hermetic connectors
Inductors
Insulators
Interposers
Limiters
Mixers
Modulators
Oscillators
PCB Prototyping
Phase shifters
Polarization tees
Power dividers
Quartz, TCXO, VCXO, OCXO
Radio frequency absorbers & shields
Radio frequency switch
Replacement of obsolescence
RF & microwave amplifiers
RF links on optical fibers
Rotating joints
Software
Substrate
Surge arresters
Thermoregulated plates
Thermoregulators
Transformers
Transition
VCO
YIG
Coaxial fixed terminations absorb RF & microwave energy and are commonly used as dummy loads of antenna and transmitter.
They are also used as match ports in many multi-port microwave device such as circulators and directional couplers to make these ports which are not involved in the measurement be terminated in their characteristic impedance in order to ensure an accurate measurement.
Our range of coaxial fixed termination feature wide frequency band up to 50 GHz, low VSWR, excellent capacity in anti-pulse and anti-burnout.
Download the selection guide
Jye Bao, which manufactures radio-frequency (RF) and microwave (HF) components, offers a range of through-loads to complement its range of coaxial loads.
In addition to its range of coaxial terminations, Jye bao has also a range of Feed through terminations are used to match 50 Ohm or 75 Ohm lines to higher impedance inputs of electronic instruments, such as oscilloscopes with typically 1M Ohm input impedance.
Terminations, or loads, offered by MECA are matched to 50 ohms characteristic impedance.
Matched loads provide a termination designed to absorb all the incident power with very little reflection, effectively terminating the line or port in its characteristic impedance.
Terminations are used in a wide variety of measurement systems; any port of a multi-port microwave device that is not involved in the measurement should be terminated in its characteristic impedance in order to ensure an accurate measurement.
Terminations are also used in devices such as directional couplers and isolators.
High power versions are used in transmitter applications as dummy loads.
Vector Telecom supplies radio frequency (RF) and microwave (HF) components, microwave waveguide assemblies, coaxial components and antennas to the global market.
Vector telecoms offers several ranges of coaxial loads. You can consult all their ranges on the Vector telecoms website to choose the load range best suited to your radio frequency (RF) and microwave frequency (HF) project.
01 34 94 20 40 - sales@tech-inter.eu